Wallpapers Hanging Instructions

How to install wallpapers?

Our non-woven wallpapers allow you to apply the glue directly to the walls and then paste the wallpaper on it. We call this method, paste the wall.

We use rolls that are 50 cm wide. In each of our rolls, there will be 1, 2 or 3 different panels depending on the design you chose. All our panels are 50 cm width which will be separated by a cutting line marked with A, B and C depending on the design. 

Unroll the roll entirely and pre-cut the panels. 

Please check whether everything is as it should be.  

The wall must be cleaned before you start, it must be even and smooth with no pencil traces or color variations. Decide the point where you are going to start. 

Open the glue / adhesive pot and stir well. You can use any classical glue for unvowen wallpaper. Put the glue into the bucket, put the ladder and the bucket in position. Brush the glue onto the wall at the top and bottom right up to the edge. Use a microfiber roller to paste the walls. Spread the glue on both sides a little wider than the panel. Spread the glue evenly and sufficiently thickly.

Press gently with a spatula and remove any bubbles.

Press the wallpaper onto the wall at the top and bottom.

Place the second panel against the first one, again allowing a little extra wall covering at the top and bottom.

Cut off any surplus piece in the corner against the floor and the ceiling.

Our panels perfectly match when place together side to side. 

You can continue with the remaining panels to cover the rest of the wall.

Our wallpaper is washable with a humid clean sponge, using clean water, in case you have some glue stain.

The wallpapers are easy to remove; simply peel them off the wall before redecorating.